Gym technical plans in DWG: electrical, data, mirrors and floor loading
A layout drawing shows where the equipment goes. Your electrician, AV installer and structural engineer need more than that. We deliver DWG plans that mark every power outlet, data point, mirror and equipment weight against the actual equipment positions, so the room is built right the first time.
What the drawing set covers
- Electrical: the outlet position and circuit requirement for every powered unit, including which units need a dedicated circuit.
- Low-voltage: wired network points for equipment consoles and TV or media inputs.
- Mirrors: mirror positions and sizes on the walls, set against the stations that use them.
- Equipment weight and floor loading: the weight at each position, so the structural engineer can check the slab. See our guide to gym floor loading.
- Base layout: the scaled 2D equipment layout with clearances and walkways that everything else is drawn on.
An example from a sample plan
The legend of one of our anonymised electrical plans, for a European project on 230 V mains, gives the installer requirements like these:
| Symbol | Requirement |
|---|---|
| Treadmill outlet | Dedicated grounded 10 A circuit on its own line and fuse from the distribution board. Running current is under 3 A, with short start-up peaks of 2–3 times the running load. About 285–572 W. |
| Standard outlet | Grounded outlet for other powered equipment: 1.1 A, about 250 W. |
| Data point | CAT5e Ethernet, RJ-45, for console internet access and software updates. |
| TV input | Coaxial media input, for example a cable TV tuner. |
The figures come from the data sheets of the equipment specified for that project. Another manufacturer or model gets its own figures. Open the sample plan
Why it saves money on site
A treadmill row on a shared circuit, a data point behind a cable tower or a mirror where a rack should stand are fixed after installation, usually at the client’s cost. When outlets and loads are drawn against the real equipment positions, the electrician and installer can work from the drawing without guessing.
Who uses the plans
- Architects and building engineers who need the gym’s technical requirements in their drawing set.
- Contractors and electricians who install outlets and data before the equipment arrives.
- Gym owners and procurement teams who want the fit-out priced and built from one set of drawings.
- Equipment distributors who deliver the plans as part of their project.
The plans usually come with the equipment specification, since the same list drives both.
Questions
Do you replace our electrical engineer or structural engineer?
No. We give them what the equipment needs at each position: circuits, outlets, data points and weights. The building’s electrical design and the structural sign-off stay with the engineers responsible for them.
What file formats do we get?
DWG for your architect, engineers and installers, and PDF for anyone who just needs to read the plans.
Can you work from our architect’s drawings?
Yes. Send the DWG or PDF of the floor plan and we draw the equipment and technical layers on top of it at the correct scale.
How long does it take?
About two weeks for a typical project, usually together with the 2D layout and the equipment specification.